IT-Passports.comがIT認証試験対策ツールのサイトで開発した問題集はとてもIT認証試験の受験生に適用します。IT-Passports.comが提供した研修ツールが対応性的なので君の貴重な時間とエネルギーを節約できます。
人生にはあまりにも多くの変化および未知の誘惑がありますから、まだ若いときに自分自身のために強固な基盤を築くべきです。あなた準備しましたか。IT-Passports.comのJuniperのJN0-360試験トレーニング資料は最高のトレーニング資料です。IT職員としてのあなたは切迫感を感じましたか。IT-Passports.comを選んだら、成功への扉を開きます。頑張ってください。
君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにIT-Passports.comを選択してください。IT-Passports.comはまた一年間に無料なサービスを更新いたします。
試験番号：JN0-360問題集
試験科目：Juniper 「Juniper Networks Certified Internet Specialist (JNCIS-SP)」
問題と解答：全252問
IT-Passports.comの問題集はIT専門家がJuniperのJN0-360認証試験について自分の知識と経験を利用して研究したものでございます。IT-Passports.comの問題集は真実試験の問題にとても似ていて、弊社のチームは自分の商品が自信を持っています。IT-Passports.comが提供した商品をご利用してください。もし失敗したら、全額で返金を保証いたします。
成功することが大変難しいと思っていますか。IT認定試験に合格するのは難しいと思いますか。今JuniperのJN0-360認定試験のためにため息をつくのでしょうか。実際にはそれは全く不要です。IT認定試験はあなたの思い通りに神秘的なものではありません。我々は適当なツールを使用して成功することができます。適切なツールを選択する限り、成功することは正に朝飯前のことです。どんなツールが最高なのかを知りたいですか。いま教えてあげます。IT-Passports.comのJN0-360問題集が最高のツールです。この問題集には試験の優秀な過去問が集められ、しかも最新のシラバスに従って出題される可能性がある新しい問題も追加しました。これはあなたが一回で試験に合格することを保証できる問題集です。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.it-passports.com/JN0-360.html
NO.1 You have recently implemented a graceful Routing-Engine switchover (GRES) and want to further
reduce down time if a Routing Engine (RE) failure occurs.
Which two features can be configured on this device to reduce its downtime in this situation? (Choose
two)
A.VRRP
B.GR
C.BFD
D.NSR
Answer: B D
Juniper JN0-360 JN0-360認証試験 JN0-360 JN0-360
NO.2 Click the Exhibit button
In the exhibit, OSPF routers R1, R2, R3, and R4 come up, in order, at 1-minute intervals
Which router will be the designated router?.
A.R1
B.R2
C.R3
D.R4
Answer: A
Juniper認定試験 JN0-360 JN0-360認定証 JN0-360 JN0-360問題集
NO.3 Click the Exhibit button
Based on the illustration of the VPLS topology shown in the exhibit, which statement is true?
A.PE-C must have a spanning-tree protocol enabled
B.CE-C must have BGP enabled
C.Traffic forwarded from PE-C to PE-A is forwarded on to PE-B
D.Traffic forwarded from PE-C to PE-A is not forwarded on to PE-B
Answer: D
Juniper過去問 JN0-360練習問題 JN0-360
NO.4 Which IS-IS packet is used to determine the level of an IS-IS neighbor?
A.IIH
B.LSP
C.PSNP
D.CSNP
Answer: A
Juniper JN0-360過去問 JN0-360 JN0-360
NO.5 What are two valid actions that can be applied to a frame by a Layer 2 firewall filter?
(Choose two)
A.Log
B.loss-priority
C.sample
D.count
Answer: BD
Juniper JN0-360認定資格 JN0-360 JN0-360
NO.6 What is the function of the hop limit field in the IPv6 header?
A.It limits the diameter of the network to 20 hops
B.It sets the number of hops in the network to be equal to the MPLS header time-to-live (TTL)
C.It replaces the time-to-live (TTL) field in IPv4
D.It represents future extensibility to the protocol
Answer: C
Juniper JN0-360 JN0-360 JN0-360 JN0-360
NO.7 You are logged into a router and have navigated to the (edit routing-options] level of the hierarchy. You
have been asked to create a static route that will use 10.10.10.1 as its primary next-hop and 10.10.10.5
as its secondary next-hop.
Which command correctly configures this scenario?
A.set static route 8/8 10.10.10.1 qualified-next-hop 10.10.10.5 pref 10
B.set static route 8/8 next-hop 10.10.10.1 secondary-next-hop 10.10.10.5 preference 10
C.set static route 8/8 next-hop 10.10.10.1 qualified-next-hop 10.10.10.5 preference 10
D.set static route 8/8 next-hop [10.10.10.1 10.10.10.5] pref 10
Answer: C
Juniper JN0-360過去問 JN0-360 JN0-360認定資格 JN0-360認証試験
NO.8 Which two statements describe differences between IPv4 and IPv6.? (Choose two)
A.IPsec is built into IPv6
B.IPv6 uses a 32-bit (4-byte) address and can support up to 4,294,967,296 addresses
C.IPv4 supports extension headers whereas IPv6 options are integrated into the base
D.IPv6 eliminates the need for NAT
Answer: AD
Juniper認証試験 JN0-360 JN0-360 JN0-360問題集
NO.9 You have been asked to configure an IPv6 address for a group of interfaces that could belong on
different routers. If a packet is sent to that address, it should be received by all routers in the group.
Which address type would be suited for these requirements?
A.Unicast
B.Multicast
C.Anycast
D.Broadcast
Answer: B
Juniper認証試験 JN0-360 JN0-360
NO.10 You are logged into a router and have navigated to the [edit routing-options] level of the hierarchy. You
have been asked to create a static route that will use 43 18 7 1 as its primary next-hop and 76 1310 2 as
its secondary next-hop.
Which command correctly configures this setup?
A.set static route 0/0 76.13.10.2 qualified-next-hop 43.18.7.1 pref 10
B.set static route 0/0 next-hop 43.18.7.1 secondary-next-hop 76.13.10.2 preference 10
C.set static route 0/0 next-hop [76.13.10.2 10.10.10.5] pref 10
D.set static route 0/0 next-hop 43.18.7.1 qualified-next-hop 76.13.10.2 preference 10
Answer: D
Juniper過去問 JN0-360 JN0-360 JN0-360認定証
NO.11 Which BGP state denotes a fully operational session?
A.Established
B.Active
C.Operational
D.Connect
Answer: A
Juniper JN0-360認証試験 JN0-360認定証 JN0-360認定証
NO.12 Which role does the router ID (RID) have in the BGP route selection process?
A.The router ID is evaluated immediately after MED to determine route preference
B.The router ID is evaluated last in the route selection process
C.The router ID is evaluated after the cluster length and a lower router ID is chosen
D.The router ID is evaluated after analyzing the IGP metric cost
Answer: C
Juniper練習問題 JN0-360過去問 JN0-360
NO.13 Click the Exhibit button
You work for the regional Internet service provider shown in the exhibit You have a partial BGP table and
are receiving a 10 100/16 route from your upstream ISP You have been asked to configure a default route
that can be sent to your downstream customer This route should forward customer traffic toward your
upstream Tier 11SP as long as the 10.100/16 route is present.
What would accomplish this goal?
A.Create and announce an aggregate default route
B.Create and announce a static default route with a next-hop of discard
C.Create and announce a static default route with a next-hop of reject
D.Create and announce a generated default route
E.Create an advertise-map with exist-map
Answer: E
Juniper認定証 JN0-360問題集 JN0-360 JN0-360練習問題
NO.14 You must configure an OSPF area that does not accept type 3 link-state advertisements (LSAs) from
area 0 (other than the default route) You have configured your area to be stub, but you still see type 3
LSAs.
What will account for this behavior?
A.You should have configured your area as totally stubby
B.You should have used a not-so-stubby-area
C.You are experiencing a routing loop
D.You have exported routes into OSPF
Answer: A
Juniper JN0-360認定試験 JN0-360参考書
NO.15 You have configured an IP-IP tunnel between Router A and Router B
Which Junos operational mode command is used to verify that the tunnel interface is up and operational?
A.show chassis tunnel status
B.show tunnel interface
C.show interfaces terse
D.show interfaces tunnel
Answer: C
Juniper問題集 JN0-360 JN0-360認定試験 JN0-360
NO.16 Which Junos operational mode command is used to verify that load balancing is working as expected?
A.show route all
B.show route extensive
C.show route balancing
D.show route forwarding-table
Answer: D
Juniper JN0-360認定証 JN0-360 JN0-360
NO.17 Which two values displayed in the output from the show spanning-tree MSTP configuration command
must match on all switches participating in the same MSTP region? (Choose two)
A.root bridge identifier
B.authentication checksum
C.context identifier
D.configuration digest
Answer: CD
Juniper問題集 JN0-360 JN0-360過去問 JN0-360過去問
NO.18 You have been asked to define a default gateway for traffic leaving a router. This route should use
interface so-0/0/0 as its next-hop.Which type of route would be suited for this scenario?
A.a static route
B.a generated route
C.a martian route
D.an aggregate route
Answer: A
Juniper過去問 JN0-360認定資格 JN0-360練習問題 JN0-360過去問
NO.19 Click the Exhibit button
Referring to the network illustrated in the exhibit, how does router A reach destinations in area 49.2222?
A.Router A will use the routes from area 49.2222; it learns from router B
B.Router A will see the attached bit from router B and create a default route
C.Router A must have a default route manually configured
D.Router A will receive a default route in the IS-IS update from router B
Answer: B
Juniper認定試験 JN0-360 JN0-360問題集
NO.20 Router A is an OSPF router connected to both Area 0 and Area 1 Area 1 has been configured as a stub
area Which two LSA types does Router A suppress from Area 1 ?
A.Router LSA
B.External LSA
C.Summary LSA
D.ASBR Summary LSA
Answer: B D
Juniper JN0-360認定資格 JN0-360 JN0-360
JuniperのJN0-360認定試験に関連する知識を学んで自分のスキルを向上させ、JN0-360認証資格を通して他人の認可を得たいですか。Juniperの認定試験はあなたが自分自身のレベルを高めることができます。JN0-360認定試験の資格を取ったら、あなたがより良く仕事をすることができます。この試験が非常に困難ですが、実は試験の準備時に一生懸命である必要はありません。IT-Passports.comのJN0-360問題集を利用してから、一回で試験に合格することができるだけでなく、試験に必要な技能を身につけることもできます。
没有评论:
发表评论