2013年8月19日星期一

無料にCiscoの642-691の試験問題集をダウンロード する

Ciscoの642-691認定試験は全てのIT職員にとって大変重要な試験です。この試験に受かったら、あなたは絶対職場に廃れられることはありません。しかも、昇進と高給も実現できます。Ciscoの642-691試験に受かったら成功への鍵を握ったと言った人もいます。これは間違いないです。IT-Passports.comのCiscoの642-691試験トレーニング資料はあなたが成功へのショートカットです。このトレーニング資料を持っていたら、成功への道を見つけます。


わずか数年の中に、Cisco 642-691認定試験がたくさんの人の日常生活にとても大きい影響を与えています。簡単で順調にCisco 642-691認定試験を通すのは問題になりますが、IT-Passports.comはこの問題を解決できるよ。弊社の問題集はIT技術者がこつこつ研究して、正確で最新なもので君の642-691認定試験を簡単に通すことにいいトレーニングツールになりますよ。IT-Passports.comを選られば、成功しましょう。


同じ目的を達成するためにいろいろな方法があって、多くの人がいい仕事とすばらしい生活を人生の目的にしています。IT-Passports.comが提供した研修ツールはCiscoの642-691の認定試験に向けて学習資料やシミュレーション訓練宿題で、重要なのは試験に近い練習問題と解答を提供いたします。IT-Passports.com を選ばれば短時間にITの知識を身につけることができて、高い点数をとられます。


今の競争の激しいIT業界では、多くの認定試験の合格証明書が君にをとんとん拍子に出世するのを助けることができます。多くの会社は君の実力と昇進がその証明書によって判断します。Ciscoの642-691認証試験はIT業界の中で含金度高い試験で、IT-Passports.comがCiscoの642-691認証試験について対応性の訓練 を提供しておって、ネットで弊社が提供した部分の問題集をダウンロードしてください。


IT-Passports.com のCiscoの642-691問題集は100パーセント検証とテストを通過したもので、認定試験に合格する専門的な指導者です。IT-Passports.com のCiscoの642-691練習問題集と解答は実践の検査に合格したソフトウェアで、最も受験生に合うトレーニングツールです。 IT-Passports.comで、あなたは一番良い準備資料を見つけられます。その資料は練習問題と解答に含まれています。弊社の資料があなたに練習を実践に移すチャンスを差し上げ、あなたはぜひCiscoの642-691試験に合格して自分の目標を達成できます。


Ciscoの642-691試験に受かることは確かにあなたのキャリアに明るい未来を与えられます。Ciscoの642-691試験に受かったら、あなたの技能を検証できるだけでなく、あなたが専門的な豊富の知識を持っていることも証明します。IT-Passports.comのCiscoの642-691試験トレーニング資料は実践の検証に合格したソフトで、手に入れたらあなたに最も向いているものを持つようになります。 IT-Passports.comのCiscoの642-691試験トレーニング資料を購入する前に、無料な試用版を利用することができます。そうしたら資料の高品質を知ることができ、一番良いものを選んだということも分かります。


IT-Passports.comのCiscoの642-691試験トレーニング資料の知名度が非常に高いことを皆はよく知っています。IT-Passports.com は世界的によく知られているサイトです。どうしてこのような大きな連鎖反応になりましたか。それはIT-Passports.comのCiscoの642-691試験トレーニング資料は適用性が高いもので、本当にみなさんが良い成績を取ることを助けられるからです。


試験番号:642-691問題集

試験科目:Cisco 「CCIP BGP + MPLS Exam (BGP + MPLS)」

問題と解答:全80問

購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード:http://www.it-passports.com/642-691.html


NO.1 Refer to the diagram.
What problem can be caused by the second P router summarizing the loopback address of the egress PE
router.?
A. The first P router will be faced with a VPN label which it does not understand.
B. The second P router will be faced with a VPN label which it does not understand.
C. The egress PE router will not be able to establish a label switch path (LSP) to the ingress PE router.
D. A label switch path (LSP) will be established from the ingress PE router to the egress PE router, an
event that is not desirable.
E. The ingress PE router will not be able to receive the VPN label from the egress PE router via MP-IBGP.
Answer: B

Cisco認定証   642-691認証試験   642-691認証試験   642-691

NO.2 What does the following command accomplish?
sanjose#clear ip bgp 10.1.1.1 in prefix-filter
A. The sanjose router will perform an outbound soft reconfig to the 10.1.1.1 neighbor.
B. The sanjose router will send out the ORF prefix-list so that a new route refresh will be received from the
1.1.1 neighbor.
C. The 10.1.1.1 router will perform an inbound soft reconfig on the updates from the sanjose neighbor.
D. The 10.1.1.1 router will send out the ORF prefix-list so that a new route refresh will be received from
the sanjose neighbor.
E. The bgp session between the sanjose and the 10.1.1.1 router will be reset so that all the new bgp
updates from the 10.1.1.1 router can be processed by the inbound prefix-list at the sanjose router.
F. The bgp session between the sanjose and the 10.1.1.1 router will be reset so that all the new bgp
updates from the sanjose router can be processed by the inbound prefix-list at the 10.1.1.1 router.
Answer: B

Cisco   642-691参考書   642-691   642-691   642-691認定証

NO.3 Refer to the exhibit.
\Which two of the following statements about the MPLS configurations are true? (Choose two.)
A. The VPI range being configured is the default VPI range.
B. The router is missing the mpls label protocol ldp configuration command on its ATM 0/0.1 subinterface
to make it an LC-ATM enabled subinterface.
C. There is a problem with the configurations because the control VC should be set to 0 32 instead.
D. The ATM switch is using VC merge since VC merge is enabled by default.
E. For MPLS label allocations, both VPI 6 and 7 can be used.
Answer: DE

Cisco過去問   642-691   642-691   642-691   642-691認定試験   642-691

NO.4 For which purpose is the command mpls ldp maxhops used?
A. In large ATM-MPLS networks, the LFIB can become too large and it may be necessary to limit the
maximum diameter of the MPLS LSPs.
B. Because downstream-on-demand label allocation uses hop count to control loop detection, it maybe
necessary to limit the maximum diameter of the MPLS network.
C. Because end-to-end delay can cause problems with some voice applications, it may be necessary to
limit the maximum diameter of the MPLS network.
D. When interconnecting large frame mode MPLS and cell mode networks it may be necessary to limit the
maximum network diameter to prevent forwarding loops.
Answer: B

Cisco認証試験   642-691認定証   642-691   642-691

NO.5 Based on the topology diagram shown in the exhibit, when should BGP be used as the routing protocol
between the customer and the ISP?
A. If physical link failures can not be detected by the link-level procedures.
B. If the customer wants to affect how the ISP will route the customer's traffic out to the rest of the Internet.
C. If the ISP does not support static routing with the customer.
D. If the customer is using provider-assigned (PA) addresses inside the customer's network.
E. If the customer is using private addresses inside the customer's network.
Answer: A

Cisco認証試験   642-691認定資格   642-691   642-691

NO.6 What are three drawbacks of a peer-to-peer VPN using a shared provider edge (PE) router? (Choose
three.)
A. A full mesh of virtual circuits is required between the customer sites.
B. All the customers have to share a common IP address space.
C. Optimal routing between customer sites cannot be guaranteed.
D. The shared PE router has to know all routes for all customers.
E. Packet filters are required on the PE routers.
Answer: BDE

Cisco   642-691   642-691練習問題   642-691過去問

NO.7 Which two of the following statements regarding LDP are true? (Choose two.)
A. LDP can also be used between nonadjacent routers using multicast LDP hello messages.
B. LDP does not require periodic hello messages once the LDP session has been established between
the LDP peers.
C. LDP hello messages use TCP packets with a destination port number of 646.
D. Multiple sessions can be established between a pair of LSRs if they use multiple label spaces.
E. Per-platform label space can be identified by a label space ID of 0 in the LDP identifier field.
Answer: DE

Cisco認定試験   642-691認定試験   642-691認定資格   642-691問題集

NO.8 In a central services topology, which routes do client VRFs contain?
A. routes from the client site, but not from the server site
B. routes from the server site, but not from the client site
C. routes from both the client site and the server site
D. only EBGP routes from either the client site or the server site
Answer: C

Cisco認証試験   642-691認定資格   642-691   642-691問題集

NO.9 On a dedicated subinterface implementation, PE-2 must establish an address-family vrf IPv4 BGP
neighbor relationship with which router?
A. CE-1
B. CE-2
C. PE-1
D. PE-IG
E. CE-1 and CE-2
F. PE-1 and PE-IG
Answer: B

Cisco   642-691   642-691   642-691参考書

NO.10 Based on the network diagram shown in the exhibit, what is the correct configuration on the customer
edge router used to conditionally announce the customer networks to the ISP?
A. router bgp 65001
! neighbor commands not shown
network 192.168.8.0 mask 255.255.252.0
!
ip route 192.168.8.0 255.255.252.0 192.168.8.33
B. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0 summary-only
!
ip route 192.168.8.0 255.255.252.0 192.168.8.33
C. router bgp 65001
! neighbor commands not shown
network 192.168.8.0
network 192.168.9.0
network 192.168.10.0
network 192.168.11.0
!
ip route 192.168.8.0 255.255.255.0 null0
ip route 192.168.9.0 255.255.255.0 null0
ip route 192.168.10.0 255.255.255.0 null0
ip route 192.168.11.0 255.255.255.0 null0
D. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0 summary-only
!
router ospf 1
network 192.168.8.0 0.0.3.255 area 0
E. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0
!
ip route 192.168.8.0 255.255.252.0 null0
Answer: A

Cisco認定証   642-691   642-691   642-691認定証   642-691

IT-Passports.com を選択して100%の合格率を確保することができて、もし試験に失敗したら、IT-Passports.comが全額で返金いたします。


没有评论:

发表评论