IT業界の一员として、君はまだIT認証試験を悩んでいますか？認証試験はITの専門知識を主なテストとして別に初めてIT関連の認証試験に参加する受験生にとってはとても難しいとみされます。良い対応性の訓練が必要で、IT-Passports.com の問題集をお勧めます。
もし弊社のJuniperのJN0-360認証試験について問題集に興味があったら、購入するまえにインターネットで弊社が提供した無料な部分問題集をダウンロードして、君の試験に役に立つかどうかのを自分が判断してください。それにIT-Passports.comは一年の無料な更新のサービスを提供いたします。
Juniper JN0-360認証はIT業界にとても重要な地位があることがみんなが、たやすくその証本をとることはではありません。いまの市場にとてもよい問題集が探すことは難しいです。でも、IT-Passports.comにいつでも最新な問題を探すことができ、完璧な解説を楽に勉強することができます。
IT-Passports.com提供した商品の品質はとても良くて、しかも更新のスピードももっともはやくて、もし君はJuniperのJN0-360の認証試験に関する学習資料をしっかり勉強して、成功することも簡単になります。
試験番号：JN0-360問題集
試験科目：Juniper 「Juniper Networks Certified Internet Specialist (JNCIS-SP)」
問題と解答：全252問
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.it-passports.com/JN0-360.html
NO.1 You have configured an IP-IP tunnel between Router A and Router B
Which Junos operational mode command is used to verify that the tunnel interface is up and operational?
A.show chassis tunnel status
B.show tunnel interface
C.show interfaces terse
D.show interfaces tunnel
Answer: C
Juniper JN0-360認定試験 JN0-360認定資格 JN0-360 JN0-360 JN0-360
NO.2 Click the Exhibit button
Referring to the network illustrated in the exhibit, how does router A reach destinations in area 49.2222?
A.Router A will use the routes from area 49.2222; it learns from router B
B.Router A will see the attached bit from router B and create a default route
C.Router A must have a default route manually configured
D.Router A will receive a default route in the IS-IS update from router B
Answer: B
Juniper問題集 JN0-360過去問 JN0-360認証試験 JN0-360
NO.3 Router A is an OSPF router connected to both Area 0 and Area 1 Area 1 has been configured as a stub
area Which two LSA types does Router A suppress from Area 1 ?
A.Router LSA
B.External LSA
C.Summary LSA
D.ASBR Summary LSA
Answer: B D
Juniper認定資格 JN0-360 JN0-360認定試験
NO.4 Which Junos operational mode command is used to verify that load balancing is working as expected?
A.show route all
B.show route extensive
C.show route balancing
D.show route forwarding-table
Answer: D
Juniper認証試験 JN0-360練習問題 JN0-360
NO.5 Which two values displayed in the output from the show spanning-tree MSTP configuration command
must match on all switches participating in the same MSTP region? (Choose two)
A.root bridge identifier
B.authentication checksum
C.context identifier
D.configuration digest
Answer: CD
Juniper JN0-360 JN0-360認定試験 JN0-360認定証
NO.6 You must configure an OSPF area that does not accept type 3 link-state advertisements (LSAs) from
area 0 (other than the default route) You have configured your area to be stub, but you still see type 3
LSAs.
What will account for this behavior?
A.You should have configured your area as totally stubby
B.You should have used a not-so-stubby-area
C.You are experiencing a routing loop
D.You have exported routes into OSPF
Answer: A
Juniper認証試験 JN0-360 JN0-360 JN0-360練習問題 JN0-360
NO.7 Which role does the router ID (RID) have in the BGP route selection process?
A.The router ID is evaluated immediately after MED to determine route preference
B.The router ID is evaluated last in the route selection process
C.The router ID is evaluated after the cluster length and a lower router ID is chosen
D.The router ID is evaluated after analyzing the IGP metric cost
Answer: C
Juniper JN0-360過去問 JN0-360練習問題 JN0-360
NO.8 Click the Exhibit button
You work for the regional Internet service provider shown in the exhibit You have a partial BGP table and
are receiving a 10 100/16 route from your upstream ISP You have been asked to configure a default route
that can be sent to your downstream customer This route should forward customer traffic toward your
upstream Tier 11SP as long as the 10.100/16 route is present.
What would accomplish this goal?
A.Create and announce an aggregate default route
B.Create and announce a static default route with a next-hop of discard
C.Create and announce a static default route with a next-hop of reject
D.Create and announce a generated default route
E.Create an advertise-map with exist-map
Answer: E
Juniper練習問題 JN0-360 JN0-360過去問
NO.9 You have recently implemented a graceful Routing-Engine switchover (GRES) and want to further
reduce down time if a Routing Engine (RE) failure occurs.
Which two features can be configured on this device to reduce its downtime in this situation? (Choose
two)
A.VRRP
B.GR
C.BFD
D.NSR
Answer: B D
Juniper JN0-360 JN0-360 JN0-360認定試験 JN0-360問題集
NO.10 You have been asked to configure an IPv6 address for a group of interfaces that could belong on
different routers. If a packet is sent to that address, it should be received by all routers in the group.
Which address type would be suited for these requirements?
A.Unicast
B.Multicast
C.Anycast
D.Broadcast
Answer: B
Juniper JN0-360 JN0-360 JN0-360認定証 JN0-360問題集
NO.11 You have been asked to define a default gateway for traffic leaving a router. This route should use
interface so-0/0/0 as its next-hop.Which type of route would be suited for this scenario?
A.a static route
B.a generated route
C.a martian route
D.an aggregate route
Answer: A
Juniper JN0-360 JN0-360 JN0-360認定証
NO.12 Which IS-IS packet is used to determine the level of an IS-IS neighbor?
A.IIH
B.LSP
C.PSNP
D.CSNP
Answer: A
Juniper JN0-360 JN0-360 JN0-360練習問題
NO.13 You are logged into a router and have navigated to the [edit routing-options] level of the hierarchy. You
have been asked to create a static route that will use 43 18 7 1 as its primary next-hop and 76 1310 2 as
its secondary next-hop.
Which command correctly configures this setup?
A.set static route 0/0 76.13.10.2 qualified-next-hop 43.18.7.1 pref 10
B.set static route 0/0 next-hop 43.18.7.1 secondary-next-hop 76.13.10.2 preference 10
C.set static route 0/0 next-hop [76.13.10.2 10.10.10.5] pref 10
D.set static route 0/0 next-hop 43.18.7.1 qualified-next-hop 76.13.10.2 preference 10
Answer: D
Juniper練習問題 JN0-360練習問題 JN0-360
NO.14 What are two valid actions that can be applied to a frame by a Layer 2 firewall filter?
(Choose two)
A.Log
B.loss-priority
C.sample
D.count
Answer: BD
Juniper JN0-360認定資格 JN0-360認定資格
NO.15 Which BGP state denotes a fully operational session?
A.Established
B.Active
C.Operational
D.Connect
Answer: A
Juniper練習問題 JN0-360認定証 JN0-360認証試験
NO.16 Which two statements describe differences between IPv4 and IPv6.? (Choose two)
A.IPsec is built into IPv6
B.IPv6 uses a 32-bit (4-byte) address and can support up to 4,294,967,296 addresses
C.IPv4 supports extension headers whereas IPv6 options are integrated into the base
D.IPv6 eliminates the need for NAT
Answer: AD
Juniper練習問題 JN0-360 JN0-360 JN0-360
NO.17 Click the Exhibit button
In the exhibit, OSPF routers R1, R2, R3, and R4 come up, in order, at 1-minute intervals
Which router will be the designated router?.
A.R1
B.R2
C.R3
D.R4
Answer: A
Juniper JN0-360認定証 JN0-360 JN0-360
NO.18 You are logged into a router and have navigated to the (edit routing-options] level of the hierarchy. You
have been asked to create a static route that will use 10.10.10.1 as its primary next-hop and 10.10.10.5
as its secondary next-hop.
Which command correctly configures this scenario?
A.set static route 8/8 10.10.10.1 qualified-next-hop 10.10.10.5 pref 10
B.set static route 8/8 next-hop 10.10.10.1 secondary-next-hop 10.10.10.5 preference 10
C.set static route 8/8 next-hop 10.10.10.1 qualified-next-hop 10.10.10.5 preference 10
D.set static route 8/8 next-hop [10.10.10.1 10.10.10.5] pref 10
Answer: C
Juniper過去問 JN0-360 JN0-360 JN0-360練習問題
NO.19 Click the Exhibit button
Based on the illustration of the VPLS topology shown in the exhibit, which statement is true?
A.PE-C must have a spanning-tree protocol enabled
B.CE-C must have BGP enabled
C.Traffic forwarded from PE-C to PE-A is forwarded on to PE-B
D.Traffic forwarded from PE-C to PE-A is not forwarded on to PE-B
Answer: D
Juniper JN0-360 JN0-360 JN0-360認定資格
NO.20 What is the function of the hop limit field in the IPv6 header?
A.It limits the diameter of the network to 20 hops
B.It sets the number of hops in the network to be equal to the MPLS header time-to-live (TTL)
C.It replaces the time-to-live (TTL) field in IPv4
D.It represents future extensibility to the protocol
Answer: C
Juniper JN0-360認定証 JN0-360過去問 JN0-360 JN0-360過去問
IT-Passports.comが提供した対応性の訓練問題をテストにして初めてJuniperのJN0-360認定試験に参加する受験者の最もよいな選択でございます。真実試験問題が似てるのを確保することができて一回合格するのは目標にしています。もし試験に失敗したら、弊社が全額で返金いたします。
没有评论:
发表评论