2013年10月8日星期二

IT-Passports.comはCisco 350-001の試験問題集を提供する

チャンスは常に準備ができあがった者に属します。しかし、我々に属する成功の機会が来たとき、それをつかむことができましたか。Ciscoの350-001認定試験を受験するために準備をしているあなたは、IT-Passports.comという成功できるチャンスを掴みましたか。IT-Passports.comの350-001問題集はあなたが楽に試験に合格する保障です。この問題集は大量な時間を節約させ、効率的に試験に準備させることができます。IT-Passports.comの練習資料を利用すれば、あなたはこの資料の特別と素晴らしさをはっきり感じることができます。この問題集は間違いなくあなたの成功への近道で、あなたが十分に350-001試験を準備させます。

IT-Passports.comはたくさんIT関連認定試験の受験者に利便性を提供して、多くの人がIT-Passports.comの問題集を使うので試験に合格しますた。彼らはIT-Passports.comの問題集が有効なこと確認しました。IT-Passports.comが提供しておりますのは専門家チームの研究した問題と真題で弊社の高い名誉はたぶり信頼をうけられます。安心で弊社の商品を使うために無料なサンブルをダウンロードしてください。

試験番号:350-001問題集
試験科目:Cisco 「CCIE Routing and Switching Written」
問題と解答:全508問

IT業種が新しい業種で、経済発展を促進するチェーンですから、極めて重要な存在ということを我々は良く知っています。IT認証はIT業種での競争な手段の一つです。認証に受かったらあなたは各方面でよく向上させます。でも、受かることが難しいですから、トレーニングツールを利用するのを勧めます。トレーニング資料を選びたいのなら、IT-Passports.comのCiscoの350-001試験トレーニング資料は最高の選択です。この資料の成功率が100パーセントに達して、あなたが試験に合格することを保証します。

IT-Passports.comは頼りが強い上にサービスもよくて、もし試験に失敗したら全額で返金いたしてまた一年の無料なアップデートいたします。

全てのIT職員はCiscoの350-001試験をよく知っています。これは一般的に認められている最高級の認証で、あなたのキャリアにヘルプを与えられます。あなたはその認証を持っているのですか。Ciscoの350-001試験は非常に難しい試験ですが、IT-Passports.comのCiscoの350-001試験トレーニング資料を手に入れたら大丈夫です。試験が難しいと感じるのは良い方法を選択しないからです。IT-Passports.comを選んだら、成功の手を握ることがきるようになります。

IT-Passports.com Ciscoの350-001試験資料は特別にデザインされたもので、IT領域のエリートが組み立てられた強い団体が受験生の皆様に向いて研究した資料です。認証試験に合格したら、あなたはIT領域で国際的な価値を表すことができます。IT-Passports.comには多くのダンプおよびトレーニング資料のサプライヤーがありますから、あなたが試験に受かることを保証します。IT-Passports.comは事実を通じて話しますから、奇跡が現れるときに我々が言ったすべての言葉を証明できます。

購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード:http://www.it-passports.com/350-001.html

NO.1 When STP UplinkFast is enabled on a switch utilizing the default bridge priority, what will the new bridge
priority be changed to?
A. 8192
B. 16384
C. 49152
D. 65535
Answer: C

Cisco問題集   350-001認定資格   350-001認定試験   350-001   350-001認定試験   350-001問題集

NO.2 Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree
Protocol IEEE 802.1D.? (Choose two)
A. Designated Root Cost
B. bridge ID priority
C. max age
D. bridge ID MAC address
E. Designated Root Priority
F. forward delay
Answer: BD

Cisco   350-001問題集   350-001

NO.3 Loop guard and UniDirectional Link Detection both protect against Layer 2 STP loops. In which two
ways does loop guard differ from UDLD in loop detection and prevention? (Choose two)
A. Loop guard can be used with root guard simultaneously on the same port on the same VLAN while
UDLD cannot.
B. UDLD protects against STP failures caused by cabling problems that create one-way links.
C. Loop guard detects and protects against duplicate packets being received and transmitted on different
ports.
D. UDLD protects against unidirectional cabling problems on copper and fiber media.
E. Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a
designated switch port
Answer: BE

Cisco練習問題   350-001   350-001認証試験   350-001

NO.4 Refer to the exhibit.
Which switching feature is being tested?
A. loop guard
B. PortFast
C. root guard
D. BDPU guard
Answer: A

Cisco   350-001   350-001認定資格   350-001

NO.5 Which standard supports multiple instances of spanning tree?
A. 802.1D
B. 802.1s
C. 802.1w
D. 802.1z
Answer: B

Cisco認証試験   350-001   350-001参考書   350-001   350-001

NO.6 The classic Spanning Tree Protocol (802.1D 1998) uses which sequence of variables to determine the
best received BPDU?
A. 1) lowest root bridge id,
2) lowest sender bridge id,
3) lowest port id,
4) lowest root path cost
B. 1) lowest root path cost,
2) lowest root bridge id,
3) lowest sender bridge id,
4) lowest sender port id
C. 1) lowest root bridge id,
2) lowest sender bridge id,
3) lowest root path cost
4) lowest sender port id
D. 1) lowest root bridge id,
2) lowest root path cost,
3) lowest sender bridge id,
4) lowest sender port id
Answer: D

Cisco   350-001   350-001認証試験

NO.7 Why does RSTP have a better convergence time than 802.1D?
A. It is newer
B. It has smaller timers
C. It has less overhead
D. It is not timer-based
Answer: D

Cisco認定資格   350-001認定資格   350-001参考書   350-001

NO.8 Under which two circumstances would an RSTP bridge flush its CAM table? (Choose two)
A. Upon a port state change
B. Upon receiving a topology change notification
C. When transitioning from discarding to forwarding
D. When transitioning from forwarding to discarding
E. Only when changing from listening to discarding
F. When CAM resources have been completely used up
Answer: BC

Cisco   350-001   350-001問題集   350-001

NO.9 Spanning Tree Protocol IEEE 802.1s defines the ability to deploy which of these?
A. one global STP instance for all VLANs
B. one STP instance for each VLAN
C. one STP instance per set of VLANs
D. one STP instance per set of bridges
Answer: C

Cisco   350-001認定証   350-001問題集   350-001参考書   350-001

NO.10 What is the purpose of the STP PortFast BPDU guard feature?
A. enforce the placement of the root bridge in the network
B. ensure that a port is transitioned to a forwarding state quickly if a BPDU is received
C. enforce the borders of an STP domain
D. ensure that any BPDUs received are forwarded into the STP domain
Answer: C

Cisco参考書   350-001   350-001   350-001

NO.11 You have done a partial migration from 802.1D STP to 802.1w STP. Which of the following is true?
A. 802.1D and 802.1w interoperate only when the 802.1D STP domain supports rapid convergence.
B. Ports leading to 802.1D devices will run in compatibility mode, while the rest of the ports will run in
802.1w mode.
C. This is an invalid configuration and a partial migration cannot be done.
D. The bridge timers will be set to match the 802.1D devices.
E. A secondary root bridge will always be populated within the 802.1D domain.
F. If the root bridge is selected within the 802.1D domain, the whole STP domain will run in 802.1D
compatibility mode.
G. In partially migrated 802.1w networks, it is recommended to keep the STP diameter below 4.
Answer: B

Cisco   350-001   350-001

NO.12 Spanning Tree Protocol calculates path cost based on which of these?
A. interface bandwidth
B. interface delay
C. interface bandwidth and delay
D. hop count
E. bridge priority
Answer: A

Cisco   350-001認定試験   350-001認定試験   350-001   350-001

NO.13 Refer to the exhibit.
In the diagram, the switches are running IEEE 802.1w RSPT.
On which ports should root guard be enabled in order to facilitate deterministic root bridge election under
normal and failure scenarios?
A. GE-3/1, GE-3/2
B. FE-2/1, FE-3/2
C. GE-1/1.GE-1/2
D. GE-4/1, GE-4/2
E. GE-2/1, GE-2/2
F. GE-3/1, GE-3/2, GE-4/1, GE-4/2, FE-2/1, FE-3/2
Answer: F

Cisco練習問題   350-001   350-001認定試験   350-001問題集

NO.14 What two features in Cisco switches help prevent Layer 2 loops? (Choose two)
A. UniDirectional Link Detection
B. Hot Standby Router Protocol
C. Virtual Router Redundancy Protocol
D. PortFast
E. Root guard
F. Loop guard
Answer: AF

Cisco認定資格   350-001   350-001参考書   350-001認定資格   350-001

NO.15 As a network administrator, can you tell me what the root guard feature provides in a bridged network?
A. It ensures that BPDUs sent by the root bridge are forwarded in a timely manner
B. It enforces the root bridge placement in the network
C. It ensures that all ports receiving BPDUs from the root bridge are in the forwarding state.
D. It ensures that the bridge is elected as Root Bridge in the network.
Answer: B

Cisco練習問題   350-001参考書   350-001問題集   350-001問題集

NO.16 Which three port states are used by RSTP 802.1w? (Choose three.)
A. Listening
B. Learning
C. Forwarding
D. Blocking
E. Discarding
F. Disabled
Answer: BCE

Cisco過去問   350-001過去問   350-001認証試験

NO.17 Which of these correctly identifies a difference between the way BPDUs are handled by 802.1w and
802.1D?
A. 802.1D bridges do not relay BPDUs.
B. 802.1w bridges do not relay BPDUs.
C. 802.1D bridges only relay BPDUs received from the root.
D. 802.1w bridges only relay BPDUs received from the root.
Answer: C

Cisco参考書   350-001認定証   350-001問題集   350-001認定試験   350-001過去問   350-001認定試験

NO.18 Refer to the exhibit.
In the diagram, the switches are running IEEE 802.1s MST. Which ports are in the MST blocking state?
A. GE-1/2 and GE-2/1
B. GE-1/1 and GE-2/2
C. GE-3/2 and GE-4/1
D. no ports are in the blocking state
E. There is not enough information to determine which ports are in the blocking state.
Answer: D

Cisco認証試験   350-001問題集   350-001   350-001練習問題   350-001参考書

NO.19 Prior to 802.1w, Cisco implemented a number of proprietary enhancements to 802.1D to improve
convergence in a Layer 2 network. Which statement is correct?
A. Only UplinkFast and BackboneFast are specified in 802.1w; PortFast must be manually configured.
B. Only PortFast is specified in 802.1w; UplinkFast and BackboneFast must be manually configured.
C. None of the proprietary Cisco enhancements are specified in 802.1w.
D. PortFast, UplinkFast, and BackboneFast are specified in 802.1w.
Answer: D

Cisco   350-001   350-001   350-001認定試験

NO.20 If a port configured with STP loop guard stops receiving BPDUs, the port will be put into which state?
A. learning state
B. listening state
C. forwarding state
D. loop-inconsistent state
Answer: D

Cisco   350-001   350-001   350-001   350-001参考書

もし君がCiscoの350-001に参加すれば、良い学習のツルを選ぶすべきです。Ciscoの350-001認定試験はIT業界の中でとても重要な認証試験で、合格するために良い訓練方法で準備をしなければなりません。。

没有评论:

发表评论