どのようにすればもっと楽にJuniperのJN0-522 JN0-532 JN0-560認定試験に合格することができるかについて考えたことがありますか。試験に合格する秘密を見つけましたか。それを行う方法がわからない場合、私は教えてあげましょう。実際には、認定試験に合格できる方法が多くあります。試験に関連する知識を一生懸命習得することがただ一つの方法です。今はそのようにしていますか。しかし、これが一番時間を無駄にして、望ましい効果を得られない方法です。それに、毎日仕事で忙しいあなたは、恐らく試験に準備する充分な時間がないでしょう。では、IT-Passports.comのJN0-522 JN0-532 JN0-560問題集を試しましょう。この試験参考書はきっとあなたに思えぬ良い結果を与えられます。
IT-Passports.comのJuniperのJN0-522 JN0-532 JN0-560試験トレーニング資料はIT認証試験を受ける人々の必需品です。このトレーニング資料を持っていたら、試験のために充分の準備をすることができます。そうしたら、試験に受かる信心も持つようになります。IT-Passports.comのJuniperのJN0-522 JN0-532 JN0-560試験トレーニング資料は特別に受験生を対象として研究されたものです。インターネットでこんな高品質の資料を提供するサイトはIT-Passports.comしかないです。
JuniperのJN0-522 JN0-532 JN0-560認定試験を受験したいですか。試験がたいへん難しいですから悩んでいるのですか。試験を申し込みたいですが、合格できないことが心配します。いまこのような気持ちを持っていますか。大丈夫ですよ。安心にJN0-522 JN0-532 JN0-560試験を申し込みましょう。IT-Passports.comの試験参考書を使用する限り、どんなに難しい試験でも問題にならないです。試験に合格する自信を全然持っていなくても、IT-Passports.comのJN0-522 JN0-532 JN0-560問題集はあなたが一度簡単に成功することを保証できます。不思議と思っていますか。では、IT-Passports.comのウェブサイトへ来てもっと多くの情報をブラウズすることもできます。それに、JN0-522 JN0-532 JN0-560問題集の一部を試用することもできます。そうすると、この参考書が確かにあなたが楽に試験に合格する保障ということをきっと知るようになります。
試験番号：JN0-522問題集
試験科目：Juniper 「FXV,Associate (JNCIA-FWV)」
問題と解答：全160問
試験番号：JN0-532問題集
試験科目：Juniper 「FWV,Specialist (JNCIS -FWV)」
問題と解答：全146問
試験番号：JN0-560問題集
試験科目：Juniper 「Certified Internet Associate.....」
問題と解答：全120問
まだJuniperのJN0-522 JN0-532 JN0-560認定試験を悩んでいますかこの情報の時代の中で専門なトレーニングを選択するのと思っていますか？良いターゲットのトレーニングを利用すれば有効で君のIT方面の大量の知識を補充 できます。JuniperのJN0-522 JN0-532 JN0-560認定試験によい準備ができて、試験に穏やかな心情をもって扱うことができます。IT-Passports.comの専門家が研究された問題集を利用してください。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.it-passports.com/jn0-522.html
NO.1 Which command can you use to view the log of IKE negotiations and results?
A.get event type 536
B.get ike cookie
C.get sa active
D.debug ike basic
Answer:A
Juniper認定資格 JN0-522認定証 JN0-522 JN0-522 JN0-522 JN0-522
NO.2 You enter the following command: set int e0/8 mip 1.1.8.32 host 10.1.10.32 netmask 255.255.255.255
How many MIP address translations have you just configured?
A.1
B.8
C.128
D.256
Answer:A
Juniper認定証 JN0-522 JN0-522認証試験
NO.3 What is the purpose of the "Permitted IP" address on a ScreenOS device?
A.It defines a list of addresses that are trusted to perform management on the ScreenOS device.
B.It is used in policy rules to determine which user traffic is allowed through the ScreenOS device.
C.It defines which range of addresses that can access devices connected to the ScreenOS device.
D.It is the address that an external device uses to gain management access to a ScreenOS device.
Answer:A
Juniper JN0-522認定証 JN0-522練習問題 JN0-522 JN0-522認定試験
NO.4 What are two benefits of configuring a ScreenOS device in transparent mode? (Choose two.)
A.There is no need to reconfigure the IP addresses of routers or protected servers.
B.There is no need to create MIPs or VIPs for incoming traffic to reach protected servers.
C.Policies are easier to create since you do not have to include source and destination IP addresses.
D.The product can support more VPNs and obtain greater throughput because there is less overhead to
manage.
Answer:A B
Juniper認定試験 JN0-522 JN0-522認定証 JN0-522練習問題
NO.5 Click the Exhibit button. In the exhibit, which routing command would allow host A to communicate with
host C? (Note: Assume a route from the SSG 20 to host A's subnet already exists.)
A.set route 0.0.0.0/0 int e0/3 gateway 177.11.56.254
B.set route 1.1.70.0 interface e0/3 gateway 177.11.56.254
C.configure route 1.1.70.0/24 gateway 177.11.56.254 int e0/3
D.set route 1.1.70.0/24 interface e0/3 gateway 177.11.56.254
Answer:D
Juniper JN0-522過去問 JN0-522認定証 JN0-522認定証
NO.6 Which ScreenOS CLI command is required to enable a policy during specified times, days, or dates?
A.set time
B.set clock
C.set calendar
D.set scheduler
Answer:D
Juniper JN0-522問題集 JN0-522 JN0-522
NO.7 Click the Exhibit button. Traffic from the Internet to the partner servers must use a VIP. In the exhibit,
what is true about the configuration of this feature?
A.You cannot use a VIP in this environment.
B.The VIP can be configured on the e0/4 interface.
C.The VIP can be configured in the Corporate or Internet zone using a different subnet than the physical
interface.
D.The VIP will work only if the destination ports in the incoming packet headers are mapped to the same
ports in the Corporate zone.
Answer:A
Juniper認定試験 JN0-522認定証 JN0-522 JN0-522認定試験
NO.8 Which ScreenOS CLI command would be useful for troubleshooting a policy deny?
A.get flow debug
B.debug flow basic
C.exec flow analysis
D.debug session basic
Answer:B
Juniper JN0-522 JN0-522 JN0-522認定試験
NO.9 What needs to be configured in Phase 2 of a route-based VPN, that does not need to be configured in a
policy-based VPN?
A.proxy-id
B.tunnel-binding
C.transport mode
D.custom proposals
Answer:B
Juniper JN0-522 JN0-522参考書 JN0-522問題集
NO.10 Click the Exhibit button. In the exhibit, if host A initiates a Web browsing session with host D, and the
E0/1 interface of the SSG 20 is in NAT mode, what will be the source address of the packet arriving at
host D?
A.10.1.1.1
B.10.1.10.5
C.143.45.56.1
D.143.45.56.254
Answer:C
Juniper問題集 JN0-522認定資格 JN0-522問題集 JN0-522
NO.11 Which ScreenOS CLI command would be used to view traffic logs?
A.get traffic
B.get log policy
C.get policy log
D.get log traffic
Answer:D
Juniper練習問題 JN0-522練習問題 JN0-522認定試験 JN0-522
NO.12 Click the Exhibit button. In the exhibit, what is the correct command to configure a default route on the
SSG 20?
A.set route 0.0.0.0/0 vrouter untrust
B.set route 0.0.0.0/0 interface e0/4 gateway 143.45.56.254
C.set route 0.0.0.0/0 interface e0/4 next-hop 143.45.56.254
D.set route 0.0.0.0/0 interface 143.45.56.1 gate 143.45.56.254
Answer:B
Juniper JN0-522 JN0-522 JN0-522 JN0-522 JN0-522認証試験
NO.13 Click the Exhibit button. In the exhibit, what is the correct address book entry for host C?
A.set address C 1.1.70.250/32
B.set address Partner C 1.1.70.250
C.set address Partner 1.1.70.250/32
D.set address Partner C 1.1.70.250/32
Answer:D
Juniper JN0-522 JN0-522練習問題 JN0-522 JN0-522認証試験
NO.14 You want to minimize the number of IP addresses, subnets, and policies in use. How should you
configure your tunnel interface?
A.Configure the tunnel interface with an IP address with a 32 bit subnet mask.
B.Configure the tunnel interface with an IP address with a 30 bit subnet mask.
C.Configure the tunnel interface as unnumbered and place the interface in the same zone as the
designated interface.
D.Configure the tunnel interface as unnumbered, but place the tunnel interface in a different zone than the
designated interface.
Answer:C
Juniper JN0-522 JN0-522過去問 JN0-522
NO.15 What is the purpose of the VLAN1 interface?
A.It provides policy-based NAT for 802.1Q VLANs.
B.It provides an interface that can be used with 802.1Q VLANs in transparent mode.
C.It provides the ScreenOS device with a routable IP address while operating in route mode.
D.It provides an interface that can be used to remotely manage the ScreenOS device while operating in
transparent mode.
Answer:D
Juniper問題集 JN0-522 JN0-522認証試験 JN0-522認定資格
NO.16 Your VPN tunnel does not pass traffic. You run the get ike cookie command and discover that there is no
cookie. Which two should be verified? (Choose two.)
A.routes
B.Phase 1 configuration options
C.Phase 2 configuration options
D.selected quick mode encryption algorithms
Answer:A B
Juniper練習問題 JN0-522 JN0-522問題集 JN0-522参考書 JN0-522参考書
NO.17 Which statement is correct about tunnel interfaces?
A.They can have overlapping IP addresses.
B.They need to be configured in the zone where the protected resources reside.
C.They can be unnumbered and used in policy-based translations if the interface is in route mode.
D.They can be unnumbered from any interface residing on the same virtual router as the protected
resources.
Answer:D
Juniper JN0-522問題集 JN0-522 JN0-522 JN0-522
NO.18 Assuming factory default settings, which statement describes the minimum requirements for WebUI
management access to the SSG 5?
A.Connect a PC addressed on the 192.168.1.0 subnet to any interface, open a browser and access
192.168.1.1.
B.Terminate the bootup sequence from the console device, open a browser on the console device and
access 192.168.1.1.
C.Connect a PC addressed on the 192.168.1.0 subnet, to the highest numbered interface and open a
browser and access 192.168.1.1.
D.Using the CLI, define an IP address on a physical interface, connect a PC to the interface and open a
browser to the interface address.
Answer:C
Juniper認証試験 JN0-522問題集 JN0-522 JN0-522 JN0-522認定証 JN0-522認定資格
NO.19 Which ScreenOS CLI policy statement keyword would enable a policy only during specified times, days,
and/or dates?
A.at
B.calendar
C.schedule
D.scheduler
Answer:C
Juniper JN0-522 JN0-522過去問 JN0-522認定資格
NO.20 Click the Exhibit button. In the exhibit, which two forms of address translation would have generated
the output shown? (Choose two.)
A.MIP
B.NAT-src with no DIP
C.Interface-based translation
D.NAT-src with a DIP, fixed-port disabled
Answer:B C
Juniper参考書 JN0-522認定試験 JN0-522
没有评论:
发表评论